Page tree

Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Comment: Published by Scroll Versions from space ENGINES1031 and version 10.3.3

In this section:

Table of Contents
maxLevel1

Info

To enable sending results and publishing source code to DTP, you need to ensure that the connection to your DTP server is properly configured, see Connecting to DTP.

Sending Results to DTP

 

...

You can enable sending results to DTP by the report.dtp.publish property to true:

Code Block
report.dtp.publish=true

Alternatively, you can use the -publish command line switch:

Code Block
jtestcli -publish

Ant and Maven Pattern

If you use Ant or Maven, you can configure publishing results to DTP with the following pattern:

Code Block
<publish>true</publish>

Associating Results with a DTP Project

You can associate results sent to DTP with a specific DTP project by configuring the dtp.project property. For example, the following configuration will associate the results published to DTP with the "extensions" project:

Code Block
dtp.project=extensions

Publishing Source Code to DTP

By default, tested sources are sent to DTP when reporting to DTP is enabled. This enables DTP to present source code associated with findings.

You can use the report.dtp.publish.src property to disable the publishing of source code, restrict the depth of source code publishing, or enable source code publishing when sending reports to DTP is disabled.

The report.dtp.publish.src property can be set to one of the following values:

  • off: Source code is not published to DTP.
  • min: Publishes the minimal part of sources. Only the source code that has no reference to source control is published.
  • full: Publishes all sources associated with the specified scope. This is the default setting.

See Report Settings for details.

See the "Development Testing Platform User Guide" for additional information about viewing source code in DTP.

Publishing Sources to DTP Without Running Code Analysis 

...

needs to execute to send data to DTP, but you may want to send publish sources to DTP without running analysis. 

  1. Create an empty test configuration and save it to [INSTALL_DIR]/configs/user; see Configuring Test Configurations for details.
  2. Run the configuration with the appropriatly configured report.dtp.publish.src property.